Hydraulic resistance in elbow
The Elbow block represents an elbow as a local hydraulic resistance. The pressure loss is computed with the semi-empirical formula based on pressure loss coefficient, which is determined in accordance with the Crane Co. recommendations (see , p. A-29). Two types of elbow are considered: smoothly curved (standard) and sharp-edged (miter). The block covers elbows in the 5–100 mm and 0–90 degrees range.
The block is based on the Local Resistance block. It computes the pressure loss coefficient and passes its value, as well as the critical Reynolds number value, to the Local Resistance block, which computes the pressure loss according to the formulas explained in the reference documentation for that block.
The pressure loss for turbulent flow regime is determined according to the following formula:
|K||Pressure loss coefficient|
|A||Elbow cross-sectional area|
The flow regime is checked in the underlying Local Resistance block by comparing the Reynolds number to the specified critical Reynolds number value. For laminar flow regime, the formula for pressure loss computation is modified, as described in the reference documentation for the Local Resistance block.
The core data for the pressure loss coefficient computation is the table-specified relationship between the friction factor fT and the internal diameter for clean commercial steel pipes, with flow in the zone of complete turbulence (see , p. A-26). For smoothly curved, standard 90o elbows, the pressure loss coefficient is determined with the formula
For elbows with different angles, the coefficient is corrected with the relationship presented in , Fig.4.6:
where α is the elbow angle in degrees (0 ≤ α ≤ 90).
Therefore, the pressure loss coefficient for smoothly curved, standard elbows is determined with the formula
For sharp-edged, miter bends the pressure loss coefficient is determined according to the table provided in , p. A-29, as a function of the elbow diameter and angle
where 5 ≤ d ≤ 100 mm and 0 ≤ α ≤ 90 degrees.
Connections A and B are conserving hydraulic ports associated with the block inlet and outlet, respectively.
The block positive direction is from port A to port B. This means that the flow rate is positive if fluid flows from A to B, and the pressure differential is determined as .
Fluid inertia is not taken into account.
The transition between laminar and turbulent regimes is assumed to be sharp and taking place exactly at Re=Recr.
The elbow is assumed to be made of a clean commercial steel pipe.
The internal diameter of the pipe. The value must be in the range between 5 and 100 mm. The default value is 0.01 m.
The angle of the bend. The value must be in the range between 0 and 90 degrees. The default value is 90 deg.
The parameter can have one of two values: Smoothly curved elbow or Miter bend. The default value is Smoothly curved elbow.
The maximum Reynolds number for laminar flow. The transition from laminar to turbulent regime is supposed to take place when the Reynolds number reaches this value. The value of the parameter depends on geometrical profile, and the recommendations on the parameter value can be found in hydraulic textbooks. The default value is 80.
Parameters determined by the type of working fluid:
Fluid kinematic viscosity
The block has the following ports:
 Flow of Fluids Through Valves, Fittings, and Pipe, Crane Valves North America, Technical Paper No. 410M
 George R. Keller, Hydraulic System Analysis, Published by the Editors of Hydraulics & Pneumatics Magazine, 1970